Email Us

Contact Us

One-Stop Services And Solutions

One-Stop Services And Solutions Manufacturing Process

The whole process of tape production is as follows:


The raw materials of plastic particles are added to the film blowing machine, and the plastic film is blown into a plastic film with a width of about 1.3M. According to the purpose of the tape, different plastic particles and adhesive raw materials are selected and some special additives are added.

After blowing the film, put the film on the coating machine and apply the glue. In fact, this process is mainly based on the viscosity and purpose of the tape. After the coating is completed, the tape will be the tape. However, the current width is 1.3 M, there are hundreds of M in length, there are large rolls of plastic film, which are not separated.


Next, the large jumbo rolls of plastic film needs to be re-rolled into a small roll of film through a rewinder, which can be rewound according to the length of the tape we usually use.


The rewinding small film can be cut into the width required by the usual tape with a slitting machine, such as 1CM width or other widths. The most important part of tape production is film blowing and coating.  Because these two processes are semi-finished products, the following rewinding and slitting have less impact on the tape.


Have a Qestion? Contact Us
Leave your message for exclusive offers, adhesive tape, and water based acrylic adhesive.
  • Call us on:

    +86-133-7708-8811
  • Address:

    ADD.: ROOM 101 NO. 4 EAST 3RD QINXIN ROAD, DONGYONG TOWN, NANSHA DISTRICT, GUANGZHOU CHINA 511453